SAE AS18280 Fittings, 24Md Cone Flareless, Fluid Connection, 3000 Psi

作者:标准资料网时间:2024-05-18 02:57:27 浏览:9304 来源:标准资料网

Product Code:SAE AS18280
Title:Fittings, 24Md Cone Flareless, Fluid Connection, 3000 Psi
Issuing Committee:G-3, Aerospace Couplings, Fittings, Hose, Tubing Assemblies
Scope:This SAE Aerospace Standard (AS) establishes the requirements for 24掳 cone flreless fluid connection fittings and nuts, internally or externally swaged or welded sleeves or tube end adapters used only with flareless fittings and bite type flreless sleeves (see Section 6) for use in aircraft fluid systems at nominal operating pressures up to and including 3000 psi.

下载地址: 点击此处下载

返回跳至顶部

上一篇: SAE AS18280/2 Sleeve, Internally Or Externally Swaged Or Welded, 24Md Cone Flareless Fitting, 3000 Psi
下一篇: SAE AS22759/11 Wire, Electrical, Fluoropolymer-Insulated, Extruded TFE, Silver-Coated Copper Conductor, 600 Volt

Product Code:SAE J2599
Title:Fuel Filler Pipe Assembly Design Practice to Meet Low Evaporative Emission Requirements
Issuing Committee:Fuel Systems Standards Committee
Scope: This SAE Recommended Practice covers design and evaluation of the entire gasoline filler pipe assembly used on cars and light trucks with respect to compliance with CARB (California Air Resources Board) LEV II (meeting or exceeding EPA Tier 2 and EU Stage-5 evaporative emissions requirements). It is limited to an assembly which is joined to the fuel tank using either a hose, Quick Connect Coupling, or a grommet type sealing device.The Design Practice covers the filler cap, filler pipe, filler pipe assembly to tank hose, and filler pipe assembly to tank grommet or spud. It includes recommendations for design of components and assemblies intended to perform successfully in evaporative emission SHED (Sealed Housing for Evaporative Determination) tests, based on best practices known at the time of release.
Rationale: This SAE Recommended Practice covers design and evaluation of the entire gasoline filler pipe assembly used on cars and light trucks with respect to compliance with CARB (California Air Resources Board) LEV II (meeting or exceeding EPA Tier 2 and EU Stage-5 evaporative emissions requirements). It is limited to an assembly which is joined to the fuel tank using either a hose, Quick Connect Coupling, or a grommet type sealing device.The Design Practice covers the filler cap, filler pipe, filler pipe assembly to tank hose, and filler pipe assembly to tank grommet or spud. It includes recommendations for design of components and assemblies intended to perform successfully in evaporative emission SHED (Sealed Housing for Evaporative Determination) tests, based on best practices known at the time of release.

基本信息

标准名称：	28MPa无扩口拧入式45°弯管接头
中标分类：	航空、航天 >> 航空器与航天器零部件 >> 管件、卡箍、密封件
ICS分类：	航空器和航天器工程 >> 航空航天用零部件
发布日期：
实施日期：
首发日期：
作废日期：
出版日期：
页数：	6

适用范围

没有内容

前言

没有内容

引用标准

没有内容

所属分类：航空航天航空器与航天器零部件管件卡箍密封件航空器和航天器工程航空航天用零部件